如何在Linux环境创建GRE Tunnel

Question: I want to connect to remote networks by using a GRE tunnel. How can I create a GRE tunnel between two end points on Linux?
GRE tunnels are IP-over-IP tunnels which can encapsulate IPv4/IPv6 and unicast/multicast traffic. To create a GRE tunnel on Linux, you need
ip_gre kernel module, which is GRE over IPv4 tunneling driver.

So first make sure that ip_gre is loaded.

$ sudo modprobe ip_gre

$ lsmod | grep gre

ip_gre                 22432  0
gre                    12989  1 ip_gre

Here, we assume that you want to create a GRE tunnel between two interfaces with the following IP addresses.

Host A: 192.168.233.204
Host B: 172.168.10.25
On host A, run the following command.

$ sudo ip tunnel add gre0 mode gre remote 172.168.10.25 local 192.168.233.204 ttl 255

$ sudo ip link set gre0 up

$ sudo ip addr add 10.10.10.1/24 dev gre0
In the above, we create a GRE-type tunnel device called gre0, and set its remote address to 172.168.10.25. Tunneling packets will be originating from 192.168.233.204 (local IP address), and their TTL field will be set to 255. The tunnel device is
assigned IP address 10.10.10.1 with netmask 255.255.255.0.

Now verify that route for the GRE tunnel is set up correctly:

$ ip route show

default via 135.112.29.1 dev eth0  proto static
10.10.10.0/24 dev gre0  proto kernel  scope link  src 10.10.10.1

On host B, run similar commands as follows.

$ sudo ip tunnel add gre0 mode gre remote 192.168.233.204 local 172.168.10.25 ttl 255

$ sudo ip link set gre0 up

$ sudo ip addr add 10.10.10.2/24 dev gre0
At this point, a GRE tunnel should be established between host A and host B.

To verify that, from one tunneling end point, ping the other end point.

$ ping 10.10.10.2 (from host A)

PING 10.10.10.2 (10.10.10.2) 56(84) bytes of data.
64 bytes from 10.10.10.2: icmp_req=1 ttl=64 time=0.619 ms
64 bytes from 10.10.10.2: icmp_req=2 ttl=64 time=0.496 ms
64 bytes from 10.10.10.2: icmp_req=3 ttl=64 time=0.587 ms

If you want to tear down the GRE tunnel, run the following command from either end.

$ sudo ip link set gre0 down
$ sudo ip tunnel del gre0

转自：http://blog.csdn.net/jjw97_5/article/details/41747557