Linux下在防火墙中开启80端口、3306端口的方法

vi /etc/sysconfig/iptables

-A INPUT -m state –state NEW -m tcp -p tcp –dport 80 -j ACCEPT（允许80端口通过防火墙）

-A INPUT -m state –state NEW -m tcp -p tcp –dport 3306 -j ACCEPT（允许3306端口通过防火墙）

特别提示：很多网友把这两条规则添加到防火墙配置的最后一行，导致防火墙启动失败，正确的应该是添加到默认的22端口这条规则的下面

添加好之后防火墙规则如下所示：

# Firewall configuration written by system-config-firewall

# Manual customization of this file is not recommended.

*filter

:INPUT ACCEPT [0:0]

:FORWARD ACCEPT [0:0]

:OUTPUT ACCEPT [0:0]

-A INPUT -m state –state ESTABLISHED,RELATED -j ACCEPT

-A INPUT -p icmp -j ACCEPT

-A INPUT -i lo -j ACCEPT

-A INPUT -m state –state NEW -m tcp -p tcp –dport 22 -j ACCEPT

-A INPUT -m state –state NEW -m tcp -p tcp –dport 80 -j ACCEPT

-A INPUT -m state –state NEW -m tcp -p tcp –dport 3306 -j ACCEPT

-A INPUT -j REJECT –reject-with icmp-host-prohibited

-A FORWARD -j REJECT –reject-with icmp-host-prohibited

COMMIT

CentOS 7.0默认使用的是firewall作为防火墙，这里改为iptables防火墙。
firewall：
systemctl start firewalld.service#启动firewall
systemctl stop firewalld.service#停止firewall
systemctl disable firewalld.service#禁止firewall开机启动