no ip mroute-cache是什么意思

To configure IP multicast fast switching or multicast distributed switching (MDS), use the ip mroute-cache command in interface configuration mode. To disable either of these features, use the no form of this command. no ip mroute-cache
关闭组播高速交换缓存

r1# show ip mroute //查看多播路由表
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C - Connected,
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report,
Z - Multicast Tunnel, z - MDT-data group sender,
Y - Joined MDT-data group, y - Sending to MDT-data group
Outgoing interface flags: H - Hardware switched, A - Assert winner
Timers: Uptime/Expires
Interface state: Interface, Next-Hop or VCD, State/Mode

在使用 debugging ip packet之前，请注意：在缺省状态下，路由器进行快速交换（Netflow），或在特定配置情况下进行CEF交换。也就是说，如果这些方法可用，则不向处理器提供数据包，因此，调试不显示任何内容。若要使调试显示内容，则需要通过no ip route-cache (适用于单点发送数据包)或no ip mroute-cache(适用于组播数据包)来禁止路由器上的快速交换。