CentOS 6.2 ifcfg-eth0 网络接口配置文件说明
2014-04-08 16:01
316 查看
#文件路径/etc/sysconfig/network-scripts/ifcfg-eth0
#文件说明TYPE=Ethernet #网卡类型
DEVICE=eth0 #网卡接口名称
ONBOOT=yes #系统启动时是否自动加载
BOOTPROTO=static #启用地址协议 --static:静态协议 --bootp协议 --dhcp协议IPADDR=192.168.1.11 #网卡IP地址
NETMASK=255.255.255.0 #网卡网络地址
GATEWAY=192.168.1.1 #网卡网关地址
DNS1=10.203.104.41 #网卡DNS地址
HWADDR=00:0C:29:13:5D:74 #网卡设备MAC地址
BROADCAST=192.168.1.255 #网卡广播地址
#使配置生效*方法1:重新导入ifcfg-eth0网络配置文件 [root@localhost ~]# /etc/init.d/network reload
Shutting down interface eth0: [ OK ]
Shutting down loopback interface: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
*方法2:重启服务[root@localhost ~]#service network restartShutting down loopback interface: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
*方法3:重启服务[root@localhost ~]# /etc/init.d/network restartShutting down loopback interface: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
*方法4:网卡接口关闭与激活
[root@localhost ~]# ifdown eth0 #关闭网卡
[root@localhost ~]# ifup eth0 #启动网卡
#临时配置网卡信息,无需重启。
[root@localhost ~]# ifconfig eth0 10.1.1.10 netmask 255.0.0.0
#状态查询*网卡[root@localhost ~]# service network status
Configured devices:lo eth0
Currently active devices:lo eth0
*路由及网关信息
[root@localhost ~]# netstat -r
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
192.168.1.0 * 255.255.255.0 U 0 0 0 eth0
169.254.0.0 * 255.255.0.0 U 0 0 0 eth0
default 192.168.1.1 0.0.0.0 UG 0 0 0 eth0
#文件说明TYPE=Ethernet #网卡类型
DEVICE=eth0 #网卡接口名称
ONBOOT=yes #系统启动时是否自动加载
BOOTPROTO=static #启用地址协议 --static:静态协议 --bootp协议 --dhcp协议IPADDR=192.168.1.11 #网卡IP地址
NETMASK=255.255.255.0 #网卡网络地址
GATEWAY=192.168.1.1 #网卡网关地址
DNS1=10.203.104.41 #网卡DNS地址
HWADDR=00:0C:29:13:5D:74 #网卡设备MAC地址
BROADCAST=192.168.1.255 #网卡广播地址
#使配置生效*方法1:重新导入ifcfg-eth0网络配置文件 [root@localhost ~]# /etc/init.d/network reload
Shutting down interface eth0: [ OK ]
Shutting down loopback interface: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
*方法2:重启服务[root@localhost ~]#service network restartShutting down loopback interface: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
*方法3:重启服务[root@localhost ~]# /etc/init.d/network restartShutting down loopback interface: [ OK ]
Bringing up loopback interface: [ OK ]
Bringing up interface eth0: [ OK ]
*方法4:网卡接口关闭与激活
[root@localhost ~]# ifdown eth0 #关闭网卡
[root@localhost ~]# ifup eth0 #启动网卡
#临时配置网卡信息,无需重启。
[root@localhost ~]# ifconfig eth0 10.1.1.10 netmask 255.0.0.0
#状态查询*网卡[root@localhost ~]# service network status
Configured devices:lo eth0
Currently active devices:lo eth0
*路由及网关信息
[root@localhost ~]# netstat -r
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
192.168.1.0 * 255.255.255.0 U 0 0 0 eth0
169.254.0.0 * 255.255.0.0 U 0 0 0 eth0
default 192.168.1.1 0.0.0.0 UG 0 0 0 eth0
相关文章推荐
- CentOS下的网络配置文件说明
- CentOS网络接口配置文件ifcfg-eth详解
- Linux网络接口配置文件ifcfg-eth0解析
- Linux网络接口配置文件ifcfg-eth0解析
- Linux网络接口配置文件ifcfg-eth0解析
- Red Hat & CentOS Linux 网络相关配置文件说明
- CentOS网络接口配置文件ifcfg-eth详解
- CentOS网络接口配置文件ifcfg-eth详解
- Gentoo 网络接口配置文件说明
- Linux网络接口配置文件ifcfg-eth0解析
- CentOS网络接口配置文件ifcfg-eth详解
- CentOS中网络配置相关文件配置选项说明
- Ubuntu网络接口配置文件:nano/etc/network/interfaces 以及 Ifconfig只显示一个lo
- Centos重新启动网络配置文件,/etc/resolv.conf被覆盖或清空问题解决
- Linux网络管理员手册(5) 第五章 配置TCP/IP网络 proc文件系统 设置主机名 分配IP地址 IP的接口配置 以太网接口
- centos6.5 ifconfig -a显示为eth1,但是配置文件只有eth0
- 虚拟机 关于 centos 7 连接不到网络的解决办法 【网络配置文件】
- 刚刚安装好的Centos7虚拟机无法配置网卡eth0的配置文件
- linux -- centos 下网卡配置文件ifcfg-eth*的选项说明
- win7 CentOS 6.0 无法访问网络,使用ifconfig发现eth0网卡并没有IP等相关配置