查找出服务器无线网络速度、信号强度等

#1：找出无线网卡类型信息

$ lspci

$ lspci | grep -i wireless

$ lspci | egrep -i --color 'wifi|wlan|wireless'

#2：找出无线网卡驱动信息

$ lspci -vv -s 0c:00.0

例子：

0c:00.0 Network controller: Intel Corporation Ultimate N WiFi Link 5300

Subsystem: Intel Corporation Device 1121

Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR+ FastB2B- DisINTx-

Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- SERR-

Kernel driver in use: iwlwifi

#3：配置无线网络接口

iwconfig 网卡名

//iwconfig和ifconfig命令类似，但是这个命令是无线网卡专用的命令

例子：

wlan0 IEEE 802.11abgn ESSID:"nixcraft5g" Mode:Managed Frequency:5.18 GHz Access Point: 74:44:44:44:57:FC Bit Rate=6 Mb/s Tx-Power=15 dBm

Retry long limit:7 RTS thr:off Fragment thr:off

Encryption key:off

Power Management:off Link Quality=41/70 Signal level=-69 dBm Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0

Tx excessive retries:0 Invalid misc:28 Missed beacon:0

# iwconfig wlan0 | grep -i --color quality //查询网络连接质量

# iwconfig wlan0 | grep -i --color signal //查询信号强度

#4：动态显示连接强度

# watch -n 1 cat /proc/net/wireless